HP Cisco MDS 9140 Cisco MDS 9200 Series Hardware Installation Guide (OL-16188- - Page 80
Grounding the Chassis
View all HP Cisco MDS 9140 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 80 highlights
Grounding the Chassis Chapter 2 Installing the Cisco MDS 9200 Series • Crimping tool to crimp the grounding wire to the grounding lug. • Wire-stripping tool to remove the insulation from the grounding wire. Grounding the Chassis The chassis has a grounding pad with two threaded M4 holes for attaching a grounding lug. Figure 2-17 shows the system ground location on the Cisco MDS 9200 Series. Warning When installing or replacing the unit, the ground connection must always be made first and disconnected last. Statement 1046 Caution Cisco recommends grounding the chassis, even if the rack is already grounded. Caution All power supplies must be grounded. The receptacles of the AC power cables used to provide power to the chassis must be the grounding type, and the grounding conductors should connect to protective earth ground at the service equipment. 2-24 Cisco MDS 9200 Series Hardware Installation Guide OL-16188-01