HP Cisco MDS 9216 Cisco MDS 9000 Family Release Notes for Cisco MDS SAN-OS Rel - Page 29
Running Storage Applications on the MSM-18/4
View all HP Cisco MDS 9216 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 29 highlights
Limitations and Restrictions Send documentation comments to [email protected] These default settings are applied when a VSAN is created. However, the settings will not take effect on VSAN 1, because it exists prior to running the setup script. Therefore, when you need these settings for VSAN 1, you must explicitly issue the following commands: • zone default-zone permit vsan 1 • zoneset distribute full vsan 1 • zone mode enhanced vsan 1 Running Storage Applications on the MSM-18/4 The Cisco MDS 9000 18/4-Port Multiservice Module (MSM-18/4) does not support multiple, concurrent storage applications. Only one application, such as SME or DMM, can run on the MSM-18/4 at a time. Compatibility of Fabric Manager and Data Mobility Manager Cisco Fabric Manager in any MDS NX-OS 4.1(x) release does not support Data Mobility Manager (DMM) in any SAN-OS 3.3(x) release or in any 3.2(x) release. To use the Cisco Fabric Manager GUI for DMM, both Fabric Manager and DMM must be running NX-OS or SAN-OS software from the same release series. A Supervisor-2 Module Might Reset in Switches Running SAN-OS Release 3.2(x) An MDS 9000 switch with a Supervisor-2 module might switch over to the standby supervisor module with a reset reason of Kernel Panic. Although there is no workaround for this issue, it happens very rarely. Additional instrumentation and checks have been added to SAN-OS Release 3.4(x) and to NX-OS Release 4.2(x) to ensure that kernel panic does not occur. DDTS CSCsx18173 describes this issue. Limited ISSU Support on the MDS 9222i Switch An in-service software upgrade (ISSU) from SAN-OS Release 3.3(4a) to NX-OS Release 4.1(1b) or to NX-OS Release 4.1(1c) is not supported on the MDS 9222i switch. This limitation applies only to the MDS 9222i switch. You can perform an ISSU from SAN-OS Release 3.3(4a) to NX-OS Release 4.1(1b) or NX-OS Release 4.1(1c) on other MDS switches. ISSU upgrades from SAN-OS Release 3.3(4a) to NX-OS Release 4.1(3a) and to NX-OS Release 4.13(a) are supported on the MDS 9222i switch. OL-14116-13 Cisco MDS 9000 Family Release Notes for Cisco MDS SAN-OS Release 3.3(4a) 29