HP Cisco MDS 9216 Cisco MDS 9100 Series Hardware Installation Guide (OL-17951- - Page 78
A-1, Step 1
View all HP Cisco MDS 9216 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 78 highlights
Cisco MDS 9000 Family Telco and EIA Shelf Bracket Appendix A Cabinet and Rack Installation Send documentation comments to [email protected] To install the shelf brackets in a telco rack, follow these steps: Step 1 Position a shelf bracket inside a rack-mounting rail as shown in Figure A-1 and align the screw holes at the front of the shelf bracket with the holes in the rack-mounting rail. Then attach the shelf bracket to the rack-mounting rail using a minimum of four 12-24 or 10-24 screws. Note The bottom hole of the shelf bracket should align with the bottom hole of a rack unit on the rack-mounting rail (the hole immediately above the 1/2-in. spacing). Step 2 Step 3 Step 4 Repeat with the other shelf bracket. Verify that the shelf brackets are at the same height (using the level or tape measure as desired). Attach the crossbar to the rear of the shelf brackets as shown in Figure A-1, using the 10-32 screws. Cisco MDS 9100 Series Hardware Installation Guide A-6 OL-17951-02