HP Cisco MDS 9216i Cisco MDS 9000 Family Release Notes for Cisco MDS SAN-OS Re - Page 35
Open Caveats, After creating SANTap Control Virtual Targets CVTs or SANTap Data Virtual Targets
View all HP Cisco MDS 9216i manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 35 highlights
Caveats Send documentation comments to [email protected] • CSCso83333 Symptom: System utilization might be incorrectly displayed after the active supervisor is up for about 497 days. This is a cosmetic issue and there is no functional impact because of this. Workaround: This issue is resolved. • CSCsw87910 Symptom: When running Cisco MDS Release SAN-OS 3.3(2) with DPVM enabled, if a link flaps for a end device with DPVM enabled, you might see the following message in the output of the show logging log command: %DPVM-3-PSS_ERR: Failed to update Login info NPV contextpwwn: 50:00:00:00:aa:99:ee:44, syserr = no such pss key Workaround: This issue is resolved. • CSCta32005 Symptom: Upon receiving an OLS when a link went down, the OLS counter was not incremented. Workaround: This issue is resolved. • CSCsz22811 Symptom: Compression throughput on the MSM-18/4 module has been improved. Workaround: This issue is resolved. Open Caveats • CSCsr85709 Symptom: Under certain conditions, the port manager can take a long time to respond to a port configuration, which can trigger a set-port-configuration failure. If this occurs, then the FCIP tunnel will not come up and will stay in a disabled state. Workaround: Enter a shut command, followed by a no shut command on the FCIP interface at either end of the FCIP tunnel. • CSCsk35725 Symptom: Fabric Manager takes 2 to 3 minutes to bring up the DMM job creation wizard in a setup with 25 switches, 400 enclosures, and 2400 entries in the name server. Workaround: None. • CSCso49196 Symptom: During an upgrade from SAN-OS Release 3.2(3a) to Release 3.3(1a), when a switchover occurs to the Supervisor running Release 3.3(1a), Cisco SME traffic flows for hosts that are not connected locally to the switch that is getting upgraded, may get flapped for a very short time. This can also occur during a switchover to a Supervisor running Release 3.3(1a). Workaround: None. • CSCsq20408 Symptom: After creating SANTap Control Virtual Targets (CVTs) or SANTap Data Virtual Targets (DVTs), the running-configuration and the startup-configuration are not synchronized. Output from the show startup-config command will be different from the output of the show running-config and the startup configuration will not display SANTap configuration information. OL-14116-12 Cisco MDS 9000 Family Release Notes for Cisco MDS SAN-OS Release 3.3(4) 35