HP Cisco MDS 9216i Cisco MDS 9000 Family Fabric Manager Quick Configuration Gu - Page 22
setup, Enter, Cisco MDS 9000 Family Configuration Guide
View all HP Cisco MDS 9216i manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
Using the Switch Setup Utility Chapter 2 Initial Switch Configuration Send documentation comments to [email protected] Step 4 General Software Pentium III Embedded BIOS 2000 (tm) Revision 1.1.(0) (C) 2002 General Software, Inc.ware, Inc. Pentium III-1.1-6E69-AA6E | System BIOS Configuration, (C) 2002 General Software, Inc. | | System CPU : Pentium III | Low Memory : 630KB | | Coprocessor : Enabled | Extended Memory : 1018MB | | Embedded BIOS Date : 10/24/03 | ROM Shadowing : Enabled | Loader Loading stage1.5. Loader loading, please wait... Auto booting bootflash:/m9500-sf1ek9-kickstart-mz.2.1.1a.bin bootflash:/m9500-s f1ek9-mz.2.1.1a.bin... Booting kickstart image: bootflash:/m9500-sf1ek9-kickstart-mz.2.1.1a.bin Image verification OK Starting kernel... INIT: version 2.78 booting Checking all filesystems..... done. Loading system software Uncompressing system image: bootflash:/m9500-sf1ek9-mz.2.1.1a.bin CCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCCC INIT: Entering runlevel: 3 Make sure you enter the password you wish to assign for the admin username. ---- System Admin Account Setup ---Enter the password for "admin": Tip If you create a password that is short and easy to decipher, then your password is rejected. Be sure to configure a strong password. Passwords are case-sensitive. You must explicitly configure a password that meets the requirements listed in the "Configuring User Accounts" section in the Cisco MDS 9000 Family Configuration Guide. Note If you are running the switch setup utility for the first-time, it starts automatically. If this is not the first-time configuration, you are required to enter setup at the system prompt. Note If you do not wish to answer a previously configured question, or if you wish to skip answers to any questions, press Enter. If a default answer is not available (for example, the switch name), the switch uses what was previously configured and skips to the next question. Step 5 Enter yes to enter setup mode. This setup utility will guide you through the basic configuration of the system. Setup configures only enough connectivity for management of the system. *Note: setup is mainly used for configuring the system initially, when no configuration is present. So setup always assumes system defaults and not the current system configuration values. Press Enter at anytime to skip a dialog. Use ctrl-c at anytime to skip the remaining dialogs. Cisco MDS 9000 Family Fabric Manager Quick Configuration Guide 2-6 OL-7765-05