HP Cisco MDS 9222i HP StorageWorks C-Series iSCSI Configuration Guide (AA-RW7P - Page 23
Log On to Target-Set persistent target, Available targets window-Connected status
![]() |
View all HP Cisco MDS 9222i manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 23 highlights
Figure 11 Log On to Target-Set persistent target 3. Select the Automatically restore this connection when the system boots check box to ensure that the controller port is enabled as a persistent target. 4. Click OK. The Available Target window shows the status for the storage controller iqn as Connected (Figure 12). Figure 12 Available targets window-Connected status 5. Click the Active Sessions tab to verify the connection to the EVA. The storage controller session Status appears as Connected (Figure 13). C-Series iSCSI 23
![](/manual_guide/products/hewlettpackard-aj732a-hp-storageworks-cseries-iscsi-configuration-guide-aarw7pete-2006-9604388/23.png)
Figure 11 Log On to Target—Set persistent target
3.
Select the
Automatically restore this connection when the system boots
check box to ensure that the
controller port is enabled as a persistent target.
4.
Click
OK
.
The Available Target window shows the status for the storage controller iqn as Connected (
Figure 12
).
Figure 12 Available targets window—Connected status
5.
Click the
Active Sessions
tab to verify the connection to the EVA.
The storage controller session Status appears as Connected (
Figure 13
).
C-Series iSCSI
23