HP Cisco MDS 9500 Cisco MDS 9000 Family Release Notes for Cisco MDS SAN-OS Rel - Page 33
Workaround, Symptom, show tech, out the Enterprise License.
View all HP Cisco MDS 9500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 33 highlights
Caveats Send documentation comments to [email protected] Workaround: This issue is resolved. • CSCsz53741 Symptom: When a crossbar module fails because of sync loss, MDS 9000 switches try to recover the fabric module by power cycling the crossbar. This may result in lost data path connectivity because the recovery may not be complete. Workaround: This issue is resolved. • CSCta47460 Symptom: The Online Health Management System (OHMS) did not receive a congestion status when the ports were in a hardware failure state. Workaround: This issue is resolved. • CSCta67430 Symptom:If a host issues a tape read command with the suppress incorrect-length indicator (SILI) bit set, it is possible for the target to return a good status and not send the full read data length requested in the read command. If this occurs, FCIP tape acceleration can leave the exchange entry in an error recovery state on the FCIP target side, and remove the exchange entry on the FCIP host side. As a result, FCIP loss of sync failure can occur. Workaround: This issue is resolved. • CSCsw50311 Symptom: A upgrade to SAN-OS Release 3.2(1) from SAN-OS Release 3.0(2a) failed with the return code 0x40930014. Workaround: This issue is resolved. • CSCsy69739 Symptom: The CIM Server is returning the incorrect speed for 10-Gbps Fibre Channel ports. Workaround: This issue is resolved. • CSCsx01522 Symptom: A switch with dual supervisors may experience an active supervisor reload due to a watchdog timeout when a show tech command executes. Workaround: This issue is resolved. • CSCsz01738 Symptom: A host that is behind a NPIV F port cannot see the zoned LUNs if the addition of the F port to the zone and the zone set activation occur after an In Service Software Upgrade (ISSU). This issue applies only to an NPIV F port on MDS 9124 and MDS 9134 fabric switches. Workaround: This issue is resolved. • CSCsz10089 Symptom: The IVR over FCIP MSM-18/4 license is not using the FCIP license. Instead, it checks out the Enterprise License. Workaround: This issue is resolved. • CSCsz11613 Symptom: The otheridentifyingInfo property on the CIM Server is returning incorrect domain IDs. Workaround: This issue is resolved. • CSCsz16768 OL-14116-12 Cisco MDS 9000 Family Release Notes for Cisco MDS SAN-OS Release 3.3(4) 33