HP Cisco MDS 9500 Cisco MDS 9000 Family Release Notes for Cisco MDS NX-OS Rele - Page 51
Starting with Release 3.4.1, Fabric Manager and Device Manager will only manage MDS switches
View all HP Cisco MDS 9500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 51 highlights
Caveats Send documentation comments to [email protected] • CSCsr59106 Symptom: Performance decreases on low-bandwidth interfaces. This issue affects only the MDS 18/4 module and the MDS 9222i switch. Workaround: This issue is resolved. • CSCsr62565 Symptom: When performing a query on ni/ei cisco_zonemembersettingdata, the Common Information Model (CIM) server crashes Workaround: This issue is resolved. • CSCsr69621 Symptom: After installing a module, the module came up but was not recognized. Workaround: This issue is resolved. • CSCsr70045 Symptom: An FCIP interface with an underlying Ethernet interface set to a large MTU (for example, 9000 bytes) goes up and down when data frames are sent. Control traffic (for example, tape status check commands) are successful and do not cause the flaps. This issue occurs only on MSM-18/4 modules. Workaround: This issue is resolved. • CSCsr89410 Symptom: An FCIP interface may go up and down due to a watchdog timeout condition. This occurs only on SAN-OS Release 3.3(1c) when running FCIP tape acceleration. Workaround: This issue is resolved. • CSCsr92585 Symptom: An FCIP interface running with tape acceleration enabled may go up and down when the host is attempting SRR/REC tape error handling. This occurs when the host is attempting to use the SRR/REC Tape error handling protocol. Workaround: This issue is resolved. • CSCsu29590 Symptom: The startup configuration is inconsistent with the running configuration after a module is powered up. Workaround: This issue is resolved. • CSCsu31909 Symptom: Multiple MSM-18/4 modules in different switches show the following error: 0x40420032 Q-Engine experienced an internal hardware error, and FCIP interfaces drop in a PortChannel. Workaround: This issue is resolved. • CSCsc67248 Symptom: The SSH key information is not consistent between the CLI and the SNMP agent. Starting with Release 3.4.1, Fabric Manager and Device Manager will only manage MDS switches running Release 3.4.1 or later for the SSH feature. SSH1(rsa1) support is removed from the CLI, Fabric Manager, and Device Manager starting with Release 3.4.1 to conform with security practices. Workaround: This issue is resolved. OL-17675-02 Cisco MDS 9000 Family Release Notes for Cisco MDS NX-OS Release 4.1(1b) 51