HP Color LaserJet CM1015/CM1017 Service Manual - Page 125
Table 6-6, Misprint. Press [OK].
View all HP Color LaserJet CM1015/CM1017 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 125 highlights
Table 6-5 Firmware control-panel messages (continued) Control panel message Description Recommended action NOTE This error occurs most often when printing from a host PC. The printer test page might not produce this error. Memory low. Only one copy made. Page too complex Press OK Misprint. Press [OK]. The device does not have enough memory to complete the collated copy job. See Firmware group corrective action, below. NOTE This error occurs most often when printing from a host PC. The printer test page might not produce this error. The device could not print the current page See Firmware group corrective action, because of its complexity. below. NOTE This error occurs most often when printing from a host PC. The printer test page might not produce this error. The printed pages have been incorrectly placed on the paper. See Firmware group corrective action, below. Firmware group corrective action 1. Verify that the most current firmware is installed on the MFP. Load the most current version if necessary. 2. Perform an NVRAM initialization. 3. Add memory to the MFP. Table 6-6 Memory-card control-panel messages Control panel message Insert only 1 memory card at a time Memory card is in backwards Memory card is unsupported Description Recommended action More than one memory card has been inserted. The memory card was inserted backwards into the card slot. The memory card that you have inserted is not a type that is supported. See Memory-card group corrective action, below. See Memory-card group corrective action, below. See Memory-card group corrective action, below. The HP Color LaserJet CM1017 MFP supports the following cards: ● CompactFlash ● Ultra CompactFlash ● Smart Media ● Memory Stick ENWW Control-panel messages 115