HP DesignJet T3500 Introductory Information - Page 8
Embedded Web Server.
View all HP DesignJet T3500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
English Message or code 61:08 61:08.1 61:08.2 61:09 63:10 63:20 71.03, 71.08 74.01 74.1:04 74.8:04 75.11:10 75.21:10 76:03 78:08 79:03, 79:04 81:01 86:01 94, 94.1 6 Introductory Information Recommendation Resend the job. The job cannot be printed because it is password-protected. The job cannot be printed because it contains errors. Resend the job from the Embedded Web Server. Resend the job. • Turn off the printer using the Power button at the front. • Turn off the power switch at the rear. • Disconnect the power cord. • Reconnect the power cord and turn on the printer. • Check that the network cable is correctly connected. • Ensure that the printer's firmware is up to date. A potential problem has been detected in the network interface. • Turn off the printer using the Power button at the front. • Turn off the power switch at the rear. • Disconnect the power cord. • Reconnect the power cord and turn on the printer. • Send the same job to the printer again. • Ensure that the printer's firmware is up to date. Out of memory. To avoid this, in the HP-GL/2 driver select the Advanced tab and then Send job as a bitmap. An error occurred when loading the firmware update file. • Turn off the printer using the Power button at the front. • Turn off the power switch at the rear. • Disconnect the power cord. • Reconnect the power cord and turn on the printer. • Reload the firmware update file into the printer. Try the firmware update again. Do not try to use your computer while the update is in progress. The firmware update has failed. Your firmware file may be incorrect; try to download it again. Preventive maintenance 1 is recommended. Preventive maintenance 2 is recommended. The printer's hard disk is full. You may want to use Disk Wipe to free some space. Borderless printing not possible; setting ignored. Ensure that the loaded paper supports borderless printing. Update your printer's firmware. Lift the scanner and make sure that there are no obstacles restricting the movement of the drive roller. If the paper has jammed, clear the obstruction by following the instructions in the front panel. Lift the scanner and make sure that there are no obstacles restricting the movement of the printhead's carriage. If the paper has jammed, clear the obstruction by following the instructions in the front panel. Restart color calibration.