HP DesignJet T930 User guide - Page 42
Embedded services
View all HP DesignJet T930 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 42 highlights
Menu item IPSEC Reset Security Link Speed Sub-menu item Sub-menu item Values and Description Specify the IPsec or Firewall status on the print server. Keep: IPsec/Firewall status remains the same as currently configured. Disable: IPsec/Firewall operation on the print server is disabled. Specify whether the current security settings on the print server will be saved or reset to factory defaults. No (default): The current security settings are maintained. Yes: Security settings are reset to factory defaults. The link speed and communication mode of the print server must match the network. The available settings depend on the device and installed print server. Select one of the following link configuration settings: CAUTION: If you change the link setting, network communications with the print server and network device might be lost. Auto (default): The print server uses auto-negotiation to configure itself with the highest link speed and communication mode allowed. If auto-negotiation fails, either 100TX HALF or 10TX HALF is set depending on the detected link speed of the hub/switch port. (A 1000T halfduplex selection is not supported.) 10T Half: 10 Mbps, half-duplex operation. 10T Full: 10 Mbps, Full-duplex operation. 100TX Half: 100 Mbps, half-duplex operation. 100TX Full: 100 Mbps, full-duplex operation. 100TX Auto: Limits auto-negotiation to a maximum link speed of 100 Mbps. 1000TX Full: 1000 Mbps, full-duplex operation. Embedded services Key networking services embedded in the printer are listed below. For the latest features and services, visit http://www.hp.com/go/jetdirect. ● Configuration and Management ◦ BootP/DHCP (IPv4 only) ◦ DHCPv6 ◦ TFTP (IPv4 only) ◦ Web Proxy (Automatic/Manual cURL) ◦ LLMNR ◦ Telnet (IPv4 only) ◦ SNMP (v1, v2c, v3) agents ◦ Bonjour (for Mac OS X) 34 Chapter 4 Network configuration ENWW