HP Designjet 2500/3500cp HP DesignJet 2500/2000CP Printer - User's Guide - Page 57
If the final print is less than 50 inches long:, Working with Media, Using the Ink System UV Outside
View all HP Designjet 2500/3500cp manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 57 highlights
CAUTION Working with Media Using the Ink System UV Outside Always apply the final print to the surface by hand or using a squeegee with a low friction paper sleeve. 1 Position the final print on the surface. Measure the final print placement relative to the sides of the substrate. 2 Tape the full leading edge of the final print in the correct position. Two-inch wide masking tape is recommended for this. If the final print is less than 50 inches long: a Lift the final print up from the trailing edge. You can roll the final print up for easier handling, if desired. b Strip back some of the backing from the final print holding it away from the surface with one hand. c Starting at the leading edge (the taped edge), use your other hand to squeegee down the front surface of the final print. Use loose, easy motions to avoid stretching the final print. d Remove the masking tape when you have finished. If the final print is more than 50 inches long: a Using two people, tape the middle of the final print to the surface and then lift it up from the trailing edge. b Strip back some of the backing from the final print holding it away from the surface. c Apply one half of the final print from its outer edge. d Strip back some of the backing from the other side of the final print. Again holding it away from the surface, continue applying the final print from where you left off. e Remove the masking tape when you have finished. 3-7