HP Designjet 510 HP Designjet 510 Printer series - User's Guide: English - Page 137
Either, Enter, Cancel, Create pattern, Sheet edge not found
View all HP Designjet 510 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 137 highlights
Front-panel messages Message Explanation and action Right edge of sheet too far from load line Press ENTER to retry Press CANCEL to abort Roll edge not found Please check roll edges are non-clear Press ENTER to retry Press CANCEL to abort Roll right edge too far from load line Press ENTER to retry Press CANCEL to abort Sheet edge not found Please check sheet edges are non-clear Press ENTER to retry Press CANCEL to abort Sheet not loaded Load sheet with printed pattern During the loading of a sheet of paper, the printer has detected that the paper is too far to the left; it should be aligned close to the blue line painted on the right side of the platen. Either: Press the Enter key to restart the loading procedure; Or: Press the Cancel key to cancel paper loading. During the loading of a roll, the printer cannot detect the side edge of the paper. A possible cause is that the paper is transparent (clear); only opaque paper types are supported. Either: Press the Enter key to restart the loading procedure; Or: Press the Cancel key to cancel paper loading. During the loading of a roll of paper, the printer has detected that the paper is too far to the left; it should be aligned with the blue line painted on the right side of the platen. Either: Press the Enter key to restart the loading procedure; Or: Press the Cancel key to cancel paper loading. During the loading of a sheet, the printer cannot detect the side edge of the paper. A possible cause is that the paper is transparent (clear); only opaque paper types are supported. Either: Press the Enter key to restart the loading procedure; Or: Press the Cancel key to cancel paper loading. The printer is trying to perform a scan of the calibration pattern, but no sheet was found. Load the sheet that was printed by the Create pattern part of the calibration routine.