HP Dl180 HP Insight Server Migration Software for ProLiant User Guide - Page 58
Source physical machine prerequisites, SMP application station prerequisites
UPC - 883585990917
View all HP Dl180 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 58 highlights
Source physical machine prerequisites • A valid network connection must exist between the source and destination server. • The source server must contain an active boot partition to be migrated. • Complete any pending reboots and software installations on the source machine before initiating a migration to prevent interrupting the migration process. • Temporarily disable any antivirus software autoscans on the source machine to prevent interrupting the migration process. Re-enable the antivirus software after the migration. • To verify that the disks are not corrupted, run a disk defragmenter on the source physical machine before initiating a migration operation. • Verify that all hard drives on the source physical machine are correctly initialized (disk signature written). • Verify that all partitions on the source physical machine have a valid file system and are in a healthy state. • Disable all applications and background services on the source machine. After the migrated machine has synchronized with the new hardware and is assigned a unique network identity, appropriate applications can be manually re-enabled and configured for the new environment. • Temporarily disable HP Management Agents on the source physical machine. • During migration, the SMP Agent initiates an operating system reboot on the source physical machine. Verify that the operating system is on the first boot order. If not, then manually change the boot order by editing the [system drive]\boot.ini file or by using the bootcfg.exe tool. The SMP application supports migration of source physical machines that have operating systems installed on the primary drive (Hard Disk0) and the primary drive loaded first in the boot order. • Record the drive letter or mount point to disk-partition mapping for dynamic disk partitions before performing the migration. Any simple (non-extended) dynamic disk partitions are converted to basic disk partitions. The mapped drive letters might have to be manually reassigned after migration. NOTE: Bad blocks on Linux file systems are not supported by SMP. To verify that the source file system does not have bad blocks, run file system-specific tools. SMP application station prerequisites • Verify that Microsoft iSCSI Initiator 2.06, 2.07, or 2.08, which is required for primary mass storage driver injection, is installed and running on the SMP application station. If iSCSI Initiator is not installed, then download and install it from http://www.microsoft.com. Other versions of the initiator, including later versions, cannot be used with this version of SMP. • Valid migrated previous P2P licenses are required on the application station. Verify that adequate licenses exist by selecting the License tab in the SMP application station. • Verify that no virtualization software is installed on the SMP application station. • To prevent interrupting the migration process, temporarily disable any antivirus software autoscans on the SMP application station. Re-enable the antivirus software after the migration. Destination physical machine prerequisites • The primary storage controller must be configured with drives attached. • The destination server must be booted to SMP Boot CD and running SMP Agent. Performing a P2P migration CAUTION: If the SMP application station shuts down or fails during any migration, then the migration being performed fails. Availability of application station during complete migration cycle is required for successful migration. To start the P2P Migration Wizard: 58 Using SMP for server migration