HP Dv7 2180us HP Pavilion dv7 Entertainment PC - Maintenance and Service Guide - Page 97
Fan/heat sink assembly - clearance
UPC - 884962256480
View all HP Dv7 2180us manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 97 highlights
g. USB board (see USB board on page 83). h. System board (see System board on page 79). Remove the power connector cable: 1. Remove the Phillips PM2.5×7.0 screw (1) that secures the power connector and bracket (2) to the base enclosure. 2. Remove the power connector cable (3). Reverse this procedure to install the power connector cable. Fan/heat sink assembly NOTE: The fan/heat sink assembly spare kit includes replacement thermal material. Description For use only with computer models equipped with graphics subsystems with discrete memory For use only with computer models equipped with graphics subsystems with UMA memory Spare part number 516876-001 516331-001 NOTE: To properly ventilate the computer, allow at least a 7.6-cm (3-inch) clearance on the right side and rear panel of the computer. The computer uses an electric fan for ventilation. The fan is controlled by a temperature sensor and is designed to turn on automatically when high temperature conditions exist. These conditions are affected by high external temperatures, system power consumption, power management/battery conservation configurations, battery fast charging, and software requirements. Exhaust air is displaced through the ventilation grill located on the left side of the computer. Before removing the fan/heat sink assembly, follow these steps: 1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the computer on, and then shut it down through the operating system. 2. Disconnect all external devices connected to the computer. Component replacement procedures 89