HP ENVY 15t-3200 HP ENVY 15 - Maintenance and Service Guide - Page 82
the system board to the base enclosure
View all HP ENVY 15t-3200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 82 highlights
8. Disconnect the TouchPad LED board cable from the system board. 9. Disconnect the following cables: (1) Display panel cable (2) Bluetooth module cable (only on computer models equipped with a Bluetooth module) (3) Card Reader board cable (4) Wireless audio module connector board cable 10. Remove the six Phillips PM2.5×4.9 screws (1) and the Phillips PM2.0×2.8 screw (2) that secure the system board to the base enclosure. 11. Lift the rear edge of the system board (3) until it rests at an angle. 74 Chapter 4 Removal and replacement procedures ENWW
8.
Disconnect the TouchPad LED board cable from the system board.
9.
Disconnect the following cables:
(1)
Display panel cable
(2)
Bluetooth module cable (only on computer models equipped with a Bluetooth module)
(3)
Card Reader board cable
(4)
Wireless audio module connector board cable
10.
Remove the six Phillips PM2.5×4.9 screws
(1)
and the Phillips PM2.0×2.8 screw
(2)
that secure
the system board to the base enclosure.
11.
Lift the rear edge of the system board
(3)
until it rests at an angle.
74
Chapter 4
Removal and replacement procedures
ENWW