HP ENVY 17t-3000 HP ENVY17 Getting Started - Windows 7 (2D Models Only) - Page 45
Replacing or upgrading the hard drives, Removing and installing the primary hard drive
View all HP ENVY 17t-3000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 45 highlights
Replacing or upgrading the hard drives CAUTION: To reduce the risk of information loss or an unresponsive system: Shut down the computer before removing a hard drive from the hard drive bay. If you are not sure whether the computer is off, in the Sleep state, or in Hibernation, press the power button, and then shut down the computer through the operating system. NOTE: Some computer models can support up to three drives-two hard drives and one solid-state drive. To determine the number and type of drives installed in your computer, click Start, right-click Computer, click Manage, and then click Disk Management. NOTE: When replacing a hard drive, make sure that you save the hard drive bracket and cover. You may need these parts to install the new hard drive. Removing and installing the primary hard drive Removing the primary hard drive 1. Save your work and shut down the computer. 2. Disconnect all external devices connected to the computer. 3. Remove external power from the computer. 4. Slide the release latch (1), and then remove the hard drive cover (2). 5. Remove the service access door. a. Remove the 6 service access door screws (1). 34 Chapter 5 Maintenance