HP ENVY Rove 20-k100 HP ENVY Rove 20 Mobile All-in-One PC - Maintenance and Se - Page 45
Media card reader board, Release the media card reader board ribbon cable from the clips
View all HP ENVY Rove 20-k100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 45 highlights
Media card reader board NOTE: The media card reader board spare part kit does not include the media card reader board ribbon cable. The media card reader board ribbon cable is included in the Cable Kit, spare part number 728048-001. See Cable Kit on page 12 for more Cable Kit information. Description Media card reader board Spare part number 728068-001 Before removing the media card reader board, follow these steps: 1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the computer on, and then shut it down through the operating system. 2. Disconnect the power from the computer by unplugging the power cord from the computer. 3. Disconnect all external devices from the computer. 4. Remove the bottom cover (see Bottom cover on page 23). 5. Remove the rear cover (see Rear cover on page 26). 6. Disconnect the battery cable (see Hard drive on page 27). 7. Remove the cover bracket (see X-axis capacitor board on page 33). Remove the media card reader board: 1. Release the ZIF connector (1) to which the media card reader board ribbon cable is attached, and then disconnect the media card reader board ribbon cable from the system board. 2. Release the media card reader board ribbon cable from the clips (2) built into the middle frame. 3. Release the ZIF connector (3) to which the Windows button ribbon cable is attached, and then disconnect the Windows button ribbon cable from the media card reader board. 4. Remove the two Phillips PM3.0×4.5 screws (4) that secure the media card reader board to the middle frame and display assembly. Component replacement procedures 37