HP ENVY TouchSmart 15-j107cl HP ENVY 15 Notebook PC and HP ENVY TouchSmart 15 - Page 76
Before removing the system board, follow these steps, Display assembly see
View all HP ENVY TouchSmart 15-j107cl manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 76 highlights
Before removing the system board, follow these steps: 1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the computer on, and then shut it down through the operating system. 2. Disconnect the power from the computer by unplugging the power cord from the computer. 3. Disconnect all external devices from the computer. 4. Remove the battery (see Battery on page 41), and then remove the following components: a. Service door (see Service door on page 42) b. mSATA SSD (see mSATA SSD on page 43) c. Hard drive (see Hard drive on page 46) d. Base enclosure (see Base enclosure on page 53) e. Display assembly (see Display assembly on page 55) f. Fan (see Fan on page 63) NOTE: When replacing the system board, be sure that the following components are removed from the defective system board and installed on the replacement system board: ● Memory module (see Memory module on page 48) ● Heat sink (see Heat sink on page 70) ● Processor (see Processor on page 75) 66 Chapter 6 Removal and replacement procedures for Authorized Service Provider parts