HP ENVY TouchSmart 15-j151nr HP ENVY 15 Notebook PC and HP ENVY TouchSmart 15 - Page 65
Display assembly, Release the wireless antenna cables from the clips built into the left rear speaker
View all HP ENVY TouchSmart 15-j151nr manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 65 highlights
Reverse this procedure to install the base enclosure. Display assembly NOTE: The TouchSmart touchscreen display assembly is spared only at the component level. The non-touchscreen display assembly is spared at both the component and the subcomponent level. For more display assembly spare part information, see the individual removal subsections. Description 15.6 inch (39.80 cm), BrightView, FHD, LED, TouchSmart touchscreen display assembly 15.6 inch (39.80 cm), BrightView, HD, LED, TouchSmart touchscreen display assembly 15.6 inch (39.80 cm), BrightView, FHD, LED, non-touchscreen display assembly 15.6 inch (39.80 cm), BrightView, HD, LED, non-touchscreen display assembly Spare part number 720550-001 720549-001 720552-001 720551-001 To remove the display assembly and access the display assembly subcomponents, follow these steps: 1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the computer on, and then shut it down through the operating system. 2. Disconnect the power from the computer by unplugging the power cord from the computer. 3. Disconnect all external devices from the computer. 4. Remove the battery (see Battery on page 41), and then remove the following components: a. Service door (see Service door on page 42) b. mSATA SSD (see mSATA SSD on page 43) c. Hard drive (see Hard drive on page 46) d. Base enclosure (see Base enclosure on page 53) Remove the display assembly: 1. Release the wireless antenna cables from the clips built into the left rear speaker (1), connector board (2), and top cover (3). 2. Release the wireless antenna cables from the routing channel (4) between the subwoofer and left front speaker. 3. Disconnect the display panel cable (5) and the webcam/microphone module cable (6) from the system board. Component replacement procedures 55