HP ENVY dv6-7228nr HP ENVY dv6 Notebook PC Maintenance and Service Guide IMPOR - Page 84
Remove the Phillips PM2.0×3.5 screw, the solid-state drive slot.
View all HP ENVY dv6-7228nr manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 84 highlights
Remove the solid-state drive: 1. Remove the Phillips PM2.0×3.5 screw (1) that secures the solid-state drive to the system board. (The solid-state drive tilts up.) 2. Remove the solid-state drive by pulling the drive away from the slot at an angle (2). NOTE: The solid-state drive is designed with a notch to prevent incorrect installation into the solid-state drive slot. Reverse this procedure to install the solid-state drive. 76 Chapter 4 Removal and replacement procedures
Remove the solid-state drive:
1.
Remove the Phillips PM2.0×3.5 screw
(1)
that secures the solid-state drive to the system board.
(The solid-state drive tilts up.)
2.
Remove the solid-state drive by pulling the drive away from the slot at an angle
(2)
.
NOTE:
The solid-state drive is designed with a notch to prevent incorrect installation into
the solid-state drive slot.
Reverse this procedure to install the solid-state drive.
76
Chapter 4
Removal and replacement procedures