HP ENVY dv6-7323cl HP ENVY dv6 Notebook PC Maintenance and Service Guide IMPOR - Page 87
Solid-state drive see, Fan/heat sink assembly see
View all HP ENVY dv6-7323cl manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 87 highlights
Before removing the system board, follow these steps: 1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the computer on, and then shut it down through the operating system. 2. Disconnect the power from the computer by unplugging the power cord from the computer. 3. Disconnect all external devices from the computer. 4. Remove the battery (see Battery on page 51). 5. Remove the hard drive (see Hard drive on page 52). 6. Disconnect the wireless antenna cables from the WLAN module (see WLAN module on page 57). 7. Remove the following components: a. Optical drive (see Optical drive on page 59) b. Keyboard (see Keyboard on page 61) c. Top cover (see Top cover on page 66) When replacing the system board, be sure that the following components are removed from the defective system board and installed on the replacement system board: ● Memory module (see Memory module on page 56 ● WLAN module (see WLAN module on page 57 ● Solid-state drive (see Solid-state drive on page 75) ● Fan/heat sink assembly (see Fan/heat sink assembly on page 82) ● Processor (see Processor on page 88) Remove the system board: 1. Close the computer. 2. Turn the computer upside down, with the front toward you. 3. Disconnect the RTC battery cable (1) from the system board. Component replacement procedures 79