HP ENVY m4 HP ENVY m4 Notebook PC Maintenance and Service Guide - Page 63
Remove the system board, that secure the system board to
View all HP ENVY m4 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 63 highlights
Remove the system board: 1. Disconnect the following cables from the system board: (1) Display panel cable (2) Speaker cable (3) Optical drive connector cable (4) Power connector cable 2. Remove the three Phillips PM2.0×5.5 screws (1) that secure the system board to the base enclosure. 3. Lift the right side of the system board (2) until it rests at an angle. Component replacement procedures 55
Remove the system board:
1.
Disconnect the following cables from the system board:
(1)
Display panel cable
(2)
Speaker cable
(3)
Optical drive connector cable
(4)
Power connector cable
2.
Remove the three Phillips PM2.0×5.5 screws
(1)
that secure the system board to the
base enclosure.
3.
Lift the right side of the system board
(2)
until it rests at an angle.
Component replacement procedures
55