HP EVA4000/6000/8000 HP StorageWorks 4x00/6x00/8x00 Enterprise Virtual Array r - Page 9
Supported Fibre Channel switches, Supported disks, Important notes and workarounds
View all HP EVA4000/6000/8000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
NOTE: 1 Gb path and components have specific configuration requirements. For more information on configuration requirements and support for 2 Gb and 4 Gb EVAs, see the HP StorageWorks SAN design reference guide, which can be downloaded from the following website: http://www.hp.com/support/manuals Click Storage Networking under Storage, and then select HP StorageWorks SAN under HP StorageWorks SAN Solutions. Supported Fibre Channel switches For complete information on which Fibre Channel switches are supported on XCS 6.100 or later, see the HP StorageWorks SAN design reference guide, which can be downloaded from the following website: http://www.hp.com/support/manuals Click Storage Networking under Storage, and then select HP StorageWorks SAN under HP StorageWorks SAN Solutions. Supported disks For information about disk drive support, see HP StorageWorks Enterprise Virtual Array disk drive firmware support, available on the HP Manuals website: http://www.hp.com/support/manuals Under storage, click Disk Storage Systems, and then select the appropriate array model under EVA Disk Arrays. Important notes and workarounds This section identifies important notes and workarounds for the EVA4x00/6x00/8x00 hardware and XCS software. Similar information for related software applications is included in the following documents: • HP StorageWorks Command View EVA release notes • HP StorageWorks Replication Solutions Manager release notes These documents can be downloaded from the following website: http://www.hp.com/support/ manuals. Click Storage Software under Storage and then select your product. Any workarounds pertaining to the host operating system can be found in the operating system connectivity release notes. See "Supported operating system specifications" on page 8. Upgrading to XCS 6.200 puts asynchronous DR groups in Temp Sync state The XCS 6.xxx controller software has a Temp Sync state for DR groups that is used when a full copy is required. If the DR groups require a full copy when you initiate a controller software upgrade, the DR groups will move to the Temp Sync state upon completion of the upgrade and the full copy. You HP StorageWorks 4x00/6x00/8x00 Enterprise Virtual Array release notes (XCS 6.200) 9