HP EVA4000 HP StorageWorks Controller Blower Replacement Instructions (5697-52 - Page 1
HP EVA4000 Manual
![]() |
View all HP EVA4000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1 highlights
HP StorageWorks Controller Blower Replacement Instructions These instructions apply to the EVA 4000/6000/8000 product family. The part may also be used in other HP products. Please refer to documentation for your specific product for detailed replacement instructions. Warranty Information If the product in which this part is being replaced is still under HP warranty, then the replacement part(s) referred to in these Replacement Instructions is provided under the terms and conditions of the Hewlett-Packard Company Limited Warranty for that product. A copy of this Limited Warranty may be viewed at: http://h18006.www1.hp.com/products/storageworks/warranty.html If this is a trade sale part (product out of warranty), then the replacement part(s) referred to in these Replacement Instructions is provided under HP's express limited warranty statement, which may be viewed at: http://customerops.corp.hp.com/1sw/pdm_om/warranty_support/ policies/2330100.doc The replacement part takes on either the Limited Warranty Period of the part being replaced or a ninety-day period that begins upon installation of the replacement part, whichever is greater. The only warranty for this replacement product is as noted above. Nothing in these replacement instructions should be construed as constituting an additional warranty. The information provided in these replacement instructions is provided "AS IS" and HP is not liable for technical or editorial errors or omissions contained herein. About This Document This document describes the procedure for replacing the blower used in Enterprise Virtual Array 4000/6000/8000 products. Printed on at least 50% total recycled fiber with at least 10% post-consumer paper. © Copyright 2005 Hewlett-Packard Development Company, L.P. Second edition March 2006 Product names mentioned herein may be trademarks of their respective companies as reflected by an associated footnote. The information in this document is subject to change without notice. Printed in the U.S.A. www.hp.com Before you begin Observe the following precautions when replacing a battery. CAUTION: Removing a blower significantly changes the air flow within the enclosure. Both blowers must be installed for the enclosure to cool properly. If a blowers fails, leave it in place in the enclosure until a new blower is available to install. Parts can be damaged by electrostatic discharge. Use proper anti-static protection. Refer to the documentation that shipped with your system for additional information. Have a copy of the product User Guide available for reference. You can download a copy of the User Guide from the product support page on the HP web site. . *5697-5246* Verifying component failure Before replacing a blower, use the following methods to verify the component failure: CAUTION: If Command View EVA does not present a status consistent with that of the blower status indicators, or if Command View or the System Event Analyzer indicates multiple hardware failures, contact HP support for assistance. The HP support web site is located at http://www.hp.com/support Page 1
![](/manual_guide/products/hewlettpackard-eva4000-hp-storageworks-controller-blower-replacement-instructions-56975246-2006-b933a81/1.png)