HP EliteBook 8570w Regulatory, Safety and Environmental Notices User Guide - Page 42
Denmark, Finland, Norway, Sweden, Power supply requirements, For use in Norway - power adapter
View all HP EliteBook 8570w manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 42 highlights
Denmark For tilslutning af de øvrige ledere, se medfølgende installationsvejledning. Finland Laite on liitettävä suojamaadoituskoskettimilla varustettuun pistorasiaan. Norway Apparatet må kun tilkoples jordet stikkontakt. Sweden Apparaten skall anslutas till jordat uttag, när den ansluts till ett nätverk. Power supply requirements The power supplies on some products have external power switches. The voltage select switch feature on the product permits it to operate from any line voltage between 100-127 or 200-240 volts AC. Power supplies on those products that do not have external power switches are equipped with internal circuits that sense the incoming voltage and automatically switch to the proper voltage. For safety reasons, use only the AC adapter provided with the unit or an authorized replacement adapter from Hewlett-Packard. Replacement part numbers may be found at http://www.hp.com/cgibin/hpsupport/index.pl. For use in Norway This product is also designed for an IT power system with phase-to-phase voltage 230V. Power cord set requirements The power cord set received with the product meets the requirements for use in the country where the equipment was originally purchased. Use only the power cord provided with the unit or an authorized replacement power cord from Hewlett-Packard or an approved HP source. Replacement part numbers may be found at http://www.hp.com/cgi-bin/hpsupport/index.pl. Power cord sets for use in other countries must meet the requirements of the country where you use the product. For more information on power cord set requirements, contact your authorized HP dealer, reseller, or service provider. WARNING! Do not use power cords from other products. Mismatched power cords may result in a shock and fire hazard. The requirements listed below are applicable to all countries: 1. The power cord must be approved by an acceptable accredited agency responsible for evaluation in the country where the power cord set will be installed. 2. The length of the power cord must be between 1.8 m (6 feet) and 3.6 m (12 feet). For a power cord 2.0 m (6.56 feet) or less, the diameter of the wire must be a minimum of 0.75 mm2 or 18AWG. If the power cord is longer than 2.0 m (6.56 feet), the diameter of the wire must be a minimum of 1.0 mm2 or 16AWG. 34 Chapter 4 Safety notices for desktops, thin clients and personal workstations