HP EliteDisplay E233 User Guide - Page 26
Using the auto-adjustment function (analog input), Image Control > Auto Adjustment
View all HP EliteDisplay E233 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 26 highlights
Using the auto-adjustment function (analog input) When you first set up the monitor, conduct a Factory Reset of the computer, or change the resolution of the monitor, the Auto-Adjustment feature automatically engages, and attempts to optimize your screen for you. You may also optimize the screen performance for the VGA (analog) input at any time by using the auto button on the monitor (see your model's user guide for the specific button name) and the auto-adjustment pattern software utility on the optical disc provided (select models only). Do not use this procedure if the monitor is using an input other than VGA. If the monitor is using a VGA (analog) input, this procedure can correct the following image quality conditions: ● Fuzzy or unclear focus ● Ghosting, streaking, or shadowing effects ● Faint vertical bars ● Thin, horizontal scrolling lines ● An off-center picture To use the auto-adjustment feature: 1. Allow the monitor to warm up for 20 minutes before adjusting. 2. Press the Menu button, and then select Image Control > Auto Adjustment from the OSD menu. If the result is not satisfactory, continue with the procedure. 3. Select Open Auto-Adjustment Utility provided on the optical disc, if one is included with your monitor. The setup test pattern is displayed. 4. Press the ESC key or any other key on the keyboard to exit the test pattern. NOTE: The auto-adjustment test pattern utility can be downloaded from http://www.hp.com/support. 20 Chapter 3 Support and troubleshooting