HP Envy 13-1099xl HP ENVY 13 - Maintenance and Service Guide - Page 38
Release the zero insertion force ZIF connector, to which the keyboard cable is attached
View all HP Envy 13-1099xl manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 38 highlights
Removal and replacement procedures 3. Release the top cover by lifting the front edge 1 until it rests at an angle. 4. Disconnect the TouchPad cable 2 from the low insertion force (LIF) connector on the system board. 5. Release the zero insertion force (ZIF) connector 3 to which the keyboard cable is attached, and then disconnect the keyboard cable 4 from the system board. 6. Remove the top cover 5. Reverse this procedure to install the top cover. Maintenance and Service Guide 4-9
Removal and replacement procedures
Maintenance and Service Guide
4–9
3. Release the top cover by lifting the front edge
1
until it rests at an angle.
4. Disconnect the TouchPad cable
2
from the low insertion force (LIF) connector on the system board.
5.
Release the zero insertion force (ZIF) connector
3
to which the keyboard cable is attached, and then disconnect
the keyboard cable
4
from the system board.
6. Remove the top cover
5
.
Reverse this procedure to install the top cover.