HP G60-225CA Service Guide - Page 83
by lifting it straight up., Remove the fan/heat sink assembly
View all HP G60-225CA manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 83 highlights
✎ Due to the adhesive quality of the thermal material located between the fan/heat sink assembly and system board components, you may need to move the fan/heat sink assembly from side to side to detach the assembly. 3. Turn the system board upside down with the fan assembly toward you. Å WARNING: To avoid damage to the processor, loosen the fan/heat sink screws in the 1-2-3-4 sequence indicated. Likewise, tighten the screws in the same sequence when installing the fan/heat sink assembly. ✎ Steps 4 through 5 apply only to computer models equipped with graphics subsystems with UMA memory. 4. Following the 1, 2, 3, 4 sequence stamped into the heat sink, loosen the four Phillips PM2.0x10.0 spring-loaded captive screws 1 that secure the fan/heat sink assembly. 5. Remove the fan/heat sink assembly 2 by lifting it straight up. ✎ Steps 6 through 7 apply only to computer models equipped with graphics subsystems with discrete memory. 6. Loosen the 4 Phillips PM2.0x11.0 spring-loaded captive screws 1 that secure the fan/heatsink assembly. 7. Remove the fan/heat sink assembly 2 by lifting it straight up. Removal and replacement procedures 4-42