HP G62m-300 Compaq Presario CQ62 Notebook PC and HP G62 Notebook PC - Maintena - Page 83
of the system board., Grasp the right edge
View all HP G62m-300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 83 highlights
Removal and replacement procedures Remove the system board: 1. Disconnect the RJ-11 cable 1 from its mounting clip in the base enclosure. 2. Disconnect the optical drive connector cable 2 from the system board. 3. Disconnect the bluetooth cable 3 from the system board. 4. Disconnect the USB cable 4 from the system board. 5. Disconnect the power connector cable 5 from the system board. 6. Remove the three PM2.5×4.0 screws 1 that secure the system board to the base enclosure. 7. Grasp the right edge 2 of the system board. 8. Lift the system board 3, and pull it away from the base enclosure 4 at an angle. Reverse this procedure to install the system board. Maintenance and Service Guide 4-39
Removal and replacement procedures
Maintenance and Service Guide
4–39
Remove the system board:
1. Disconnect the RJ-11 cable
1
from its mounting clip in the base enclosure.
2. Disconnect the optical drive connector cable
2
from the system board.
3. Disconnect the bluetooth cable
3
from the system board.
4. Disconnect the USB cable
4
from the system board.
5. Disconnect the power connector cable
5
from the system board.
6. Remove the three PM2.5×4.0 screws
1
that secure the system board to the base enclosure.
7. Grasp the right edge
2
of the system board.
8. Lift the system board
3
, and pull it away from the base enclosure
4
at an angle.
Reverse this procedure to install the system board.