HP HDX X18-1018TX HP HDX 18 Entertainment PC - Maintenance and Service Guide - Page 74
to which the fingerprint reader board cable is attached and disconnect
View all HP HDX X18-1018TX manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 74 highlights
7. Remove the two Phillips PM2.5×7.0 screws that secure the top cover to the base enclosure. 8. Lift the rear edge 1 of the top cover until it rests at an angle. 9. Slide the top cover 2 back until the fingerprint reader board cable is accessible. 10. Release the ZIF connector 1 to which the fingerprint reader board cable is attached and disconnect the fingerprint reader board cable from the system board. 11. Remove the top cover 2. Reverse this procedure to install the top cover. Removal and replacement procedures 4-41
Removal and replacement procedures
4–41
7. Remove the two Phillips PM2.5×7.0 screws that secure the top cover to the base enclosure.
8. Lift the rear edge
1
of the top cover until it rests at an angle.
9. Slide the top cover
2
back until the fingerprint reader board cable is accessible.
10. Release the ZIF connector
1
to which the fingerprint reader board cable is attached and disconnect the
fingerprint reader board cable from the system board.
11. Remove the top cover
2
.
Reverse this procedure to install the top cover.