HP Indigo WS6600p Dripping Prevention and ITM Heating Hood Service -- CA393-10 - Page 11
position, while connecting the rubber seal. Tighten the 3 screws when you are finished.
View all HP Indigo WS6600p manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
2. Install the new ITM suction blower in the press using the original 3 M6 Allen screws. 3. Verify that the rubber gasket is correctly positioned on the new ITM suction blower. (You can loosen the 3 screws at the top of the suction blower bracket, to allow adjusting the blower position, while connecting the rubber seal. Tighten the 3 screws when you are finished.) 8 Chapter 2 Procedures
2.
Install the new ITM suction blower in the press using the original 3 M6 Allen screws.
3.
Verify that the rubber gasket is correctly positioned on the new ITM suction blower.
(You can loosen the 3 screws at the top of the suction blower bracket, to allow adjusting the blower
position, while connecting the rubber seal. Tighten the 3 screws when you are finished.)
8
Chapter 2
Procedures