HP Kayak XA-s 02xx hp kayak pc workstations, using sound - Page 24

Using Sound on Your PC Sound Board Connectors The AUX In connector has the following pin assignments: Pin 1 2 3 4 Signal Analog Ground AUX right channel Analog Ground AUX left channel I/O IN IN CD Audio Connector The CD Audio Connector, labeled "CDAUDIO", allows you to connect the sound board to the CD-ROM drive via the audio cable, so that you can listen to audio from the CD-ROM drive. The CD Audio Connector has the following pin assignments: Pin 1 2 3 4 Signal Analog Ground CD right channel Analog Ground CD left channel I/O IN IN Internal Speaker Connector This connector, labeled "INTERNAL_SPK", enables you to redirect sounds from the sound board to a single internal speaker, such as a speaker mounted in the chassis of the front panel in some models of HP Vectra PC models. The output to the speaker is not cut off by connecting external speakers to the LINE OUT, but it is cut off if the SPK socket is used on the sound card's rear panel. The connection is made via a two-wire cable. The Internal Speaker Connector has these pin assignments: 24 English