HP Kayak XU 04xx HP Kayak XA-s, XU, and XW PC Workstations - Familiarization G - Page 33

Complete the Questionnaire to Check Your Understanding Complete the Questionnaire to Check Your Understanding Circle each letter that corresponds to a correct answer. (There may be more than one correct answer to each question). 1 Can a 256 MB registered ECC memory module be mixed with a non-buffered ECC SDRAM memory? a Yes, it can. However, the 256 MB module must be installed in Slot 1. b No, it cannot. Registered and non-buffered memory modules are not compatible. 2 Can a maximum of 512 MB of non-buffered ECC SDRAM memory modules be installed on HP Kayak XA-s, XU, and XW Series U3 and W3 PC Workstations? a Yes, by installing 4 x 128 MB memory modules. b No. On the HP Kayak XA-s, there are only three DIMM sockets available. 3 For models with the HP FastRAID2 I/O Subsystem, can you boot from the Windows NT CD-ROM when replacing a disk drive? a Yes, because Windows NT is capable of finding a new hard disk drive. b No, because the new hard drive will not be found. 4 Where can you find all of the HP FastRAID software (ArrayConfig, drivers and CI/O Manager) and Operating System Installation notes (such as Windows NT 4.0)? a HP Kayak XU/XW PC Workstation Drivers CD-ROM. b HP's WWW site. c Netscape Communicator CD-ROM. 5 To run the MaxiLife diagnostics program, does the computer need to be powered on? a No, it doesn't. The HP MaxiLife is always running and continuously monitors the state of the LCD buttons. b Yes, it does. This can be easily checked, because the LCD status panel will be blank. c No, it doesn't. Even with the power cable disconnected, HP MaxiLife is always running and continuously monitors the state of the 33