HP LH3000r HP Netserver LH 3000 Installation Guide - Page 61
Installing Additional Memory
View all HP LH3000r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 61 highlights
5 Installing Additional Memory Introduction This chapter describes adding memory to the HP NetServer LH 3000r and LH 3000. The standard configuration ships with one 128 MB DIMM in slot 0. DIMM Socket 0 DIMM Socket 1 DIMM Socket 2 DIMM Socket 3 Figure 5-1. DIMM Sockets on System Board Assembly Memory Guidelines l Add DIMMs of these sizes: ◊ 128 Mb ◊ 256 Mb ◊ 512 Mb ◊ 1 GB l Add memory in any order to the four slots. l You can mix DIMM sizes. For example, you may place a 1 GB DIMM next to a 128 Mb DIMM. l Maximum configuration is 4 GB. l Do not rock the DIMM into place, but apply firm and even pressure until it is seated in the socket. l Use only HP-supported DIMMs. NOTE If non-HP DIMMs are used, the NetServer will report this during boot. 53