HP LH4r HP NetRAID-3Si Controller Features and Benefits - Page 3

For The Latest Information

Page 3 highlights

Product Brief HP NetServer NetRAID-3Si Specifications RAID Levels Supported SCSI Channels SCSI Connectors Devices per SCSI Channel SCSI Device Types Supported SCSI Bus Types Supported SCSI Termination Maximum SCSI Data Transfer Rates Processor BIOS RAID Parity Engine/DRAM Controller Cache Flash ROM Nonvolatile RAM Cache Backup Battery Tone Generator HP NetRAID Family Cards per System Card Size Bus Type Bus Transfer Rate Ordering Information 0,1,3,5,10,30,and 50 Three Three 68-pin, high-density internal connectors; three 68-pin, very-high-density external connectors Up to 12 Synchronous or Asynchronous Low-Voltage Differential (LVD) and Single-Ended at 16-bit (Wide) width Active termination enabled LVD: 80MB/sec (int/ext); Single-Ended; 40MG/s (int) and 20MB/s (ext) Intel i960RD 66MHz Intelligent I/O HP NetRAId Custom ASIC 16MB 60ns EDO DRAM; one 36 bit 5V SIMM 1MB used for BIOS and RAID firmware 32KB NVRAM for configuration Protects 16MB cache for 48 hours Audible warnings indicate degraded drives, offline drives, and drive rebuilds Up to 6 12.3" x 4.2" (full length PCI) PCI 2.1 (32-bit) 132 MB/sec Cables Description For internal use with HP NetServer E Series or LC family For internal use with HP NetServer LH 3, LH 4 and LX Pro For internal use with HP NetServer LPr For external connection to the HP NetServer Rack Storage/12 and HP NetServer Rack Storage/12FC 1Must order when adding an HP NetRAID family controller Product No. D5968A1 D4282B1 D7082A1 D6020A Supported HP NetServer systems: E 50, LPr, LC 3, LH 4, LXr Pro8, LXr 8000. Drivers supported: Microsoft Windows NT 3.51 and 4.0, Enterprise 4.0; Novell NetWare 3.2, 4.11, 4.11 (I20), 4.11 SFT III, and 5.0; SCO OpenServer 5.0.4; SCO Unix ODT 3.0; UnixWare 2.1.3 and 7.0; and IBM OS/2 Warp Server 4.0 For The Latest Information HP NetServer Website Http://www.hp.com/go/netserver HP FAX Response system 1-800-333-3333(U.S.) 1-333-333-3333 (worldwide from fax only) Banyan and VINES are registered trademarks of Banyan Systems, Inc. OpenView is a trademark of Hewlett-Packard Company. IBM and OS/2 are registered trademarks of IBM Corporation. Intel and Pentium are U.S. registered trademarks, and Xeon is a trademark, of Intel Corporation. Microsoft and Windows NT are registered trademarks of Microsoft Corporation. Novell and NetWare are registered trademarks of, and IntranetWare is a trademark of, Novell, Inc. SCO and UnixWare are registered trademarks of, and OpenServer is a trademark of, The Santa Cruz Operation. All other brand names are trademarks of their respective owners. Information in this document is subject to change without notice. © Copyright Hewlett-Packard Company 1998. All Rights Reserved. Reproduction, adaptation, or translation without prior written permission is prohibited except as allowed under the copyright laws. Printed in USA M0199 P/N5968-3005EUC 3

  • 1
  • 2
  • 3

3
Product Brief
HP
NetServer
NetRAID-3Si
Ordering Information
Cables
Description
Product No.
For internal use with HP NetServer E Series or LC family
For internal use with HP NetServer LH 3, LH 4 and LX Pro
For internal use with HP NetServer LPr
For external connection to the HP NetServer Rack Storage/12 and HP NetServer
Rack Storage/12FC
D5968A
1
D4282B
1
D7082A
1
D6020A
1
Must order when adding an HP NetRAID family controller
Supported HP NetServer systems: E 50, LPr, LC 3, LH 4, LXr Pro8, LXr 8000.
Drivers supported:
Microsoft Windows NT 3.51 and 4.0, Enterprise 4.0; Novell NetWare 3.2, 4.11, 4.11 (I20), 4.11 SFT III, and 5.0;
SCO OpenServer 5.0.4; SCO Unix ODT 3.0; UnixWare 2.1.3 and 7.0; and IBM OS/2 Warp Server 4.0
For The Latest Information
HP NetServer Website
Http://www.hp.com/go/netserver
HP FAX Response
system
1-800-333-3333(U.S.)
1-333-333-3333
(worldwide from fax only)
Banyan and VINES are registered trademarks of Banyan Systems, Inc. OpenView is a trademark of Hewlett-Packard Company. IBM and OS/2 are registered trademarks of IBM Corporation.
Intel and Pentium are U.S. registered trademarks, and Xeon is a trademark, of Intel Corporation.
Microsoft and Windows NT are registered trademarks of Microsoft Corporation. Novell and
NetWare are registered trademarks of, and IntranetWare is a trademark of, Novell, Inc. SCO and UnixWare are registered trademarks of, and OpenServer is a trademark of, The Santa Cruz
Operation. All other brand names are trademarks of their respective owners.
Information in this document is subject to change without notice.
© Copyright Hewlett-Packard Company 1998. All Rights Reserved. Reproduction, adaptation, or translation without prior written permission is prohibited except as allowed under the
copyright laws.
Printed in USA M0199
P/N5968-3005EUC
Specifications
RAID Levels Supported
0,1,3,5,10,30,and 50
SCSI Channels
Three
SCSI Connectors
Three 68-pin, high-density internal connectors; three 68-pin, very-high-density
external connectors
Devices per SCSI Channel
Up to 12
SCSI Device Types Supported
Synchronous or Asynchronous
SCSI Bus Types Supported
Low-Voltage Differential (LVD) and Single-Ended at 16-bit (Wide) width
SCSI Termination
Active termination enabled
Maximum SCSI Data Transfer Rates
LVD: 80MB/sec (int/ext); Single-Ended; 40MG/s (int) and 20MB/s (ext)
Processor
Intel
i960RD 66MHz Intelligent I/O
BIOS
HP NetRAId
RAID Parity Engine/DRAM Controller
Custom ASIC
Cache
16MB 60ns EDO DRAM; one 36 bit 5V SIMM
Flash ROM
1MB used for BIOS and RAID firmware
Nonvolatile RAM
32KB NVRAM for configuration
Cache Backup Battery
Protects 16MB cache for 48 hours
Tone Generator
Audible warnings indicate degraded drives, offline drives, and drive rebuilds
HP NetRAID Family Cards per System
Up to 6
Card Size
12.3” x 4.2” (full length PCI)
Bus Type
PCI 2.1 (32-bit)
Bus Transfer Rate
132 MB/sec