HP LH4r hp netserver lc 2000 netraid-2m config guide — for Micros
HP LH4r - NetServer - 256 MB RAM Manual
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
HP LH4r manual content summary:
- HP LH4r | hp netserver lc 2000 netraid-2m config guide — for Micros - Page 1
Edition Cluster Configuration Guide Introduction This document defines the server cluster configurations supported by Hewlett-Packard for interconnection of two HP Netserver LC 2000 servers and one or multiple HP Rack Storage/12 disk drive enclosure(s), with Microsoft® Cluster Server software. These - HP LH4r | hp netserver lc 2000 netraid-2m config guide — for Micros - Page 2
05.00, or later For NetRAID-1M or NetRAID-2M, mraidnt.sys, version 4.05 (all drivers obtained from Navigator CD-ROM, version L.20.00, or later) Server internal drive bays, or HP external drive cabinet (e.g., HP Rack Storage/12) Must be HP Any HP cables that meet SCSI specifications, and any SCSI bus - HP LH4r | hp netserver lc 2000 netraid-2m config guide — for Micros - Page 3
Microsoft® and HP Certified Server Configuration Parameter Server I/O controller Network interfaces Boot device Specification PCI slot 5, NetRAID-2M shared storage controller PCI slot 6, NetRAID-1M boot device PCI slot 3, client LAN Embedded NIC for intra-cluster (heartbeat) LAN NetRAID-1M Intra - HP LH4r | hp netserver lc 2000 netraid-2m config guide — for Micros - Page 4
CD-ROM L.20.00, or later) Client LAN Configuration Parameter Network Connection NIC Quantity Model Driver Specification Any LAN One, minimum Any model that is on both the HP Tested Products List and the Microsoft® Hardware Compatibility List Vendor-supported driver If the NIC used is the same as - HP LH4r | hp netserver lc 2000 netraid-2m config guide — for Micros - Page 5
-2M controllers, the maximum supported for shared storage, installed in slots 5 and 6. One or two NetRAID-2M cards may be used, and one to four RS/12s are supported. A maximum of eight logical drives are supported for the cluster. HP Netserver LC 2000 Cluster using HP Rack Storage/12 Cabling Diagram - HP LH4r | hp netserver lc 2000 netraid-2m config guide — for Micros - Page 6
lc2000nt2m Power Cabling to Separate Power Circuits 2/23/02 6 - HP LH4r | hp netserver lc 2000 netraid-2m config guide — for Micros - Page 7
Versions 23 February 2002 Initial release lc2000nt2m © Copyright 2002, Hewlett-Packard Company 2/23/02 7
2/23/02
1
HP Netserver LC 2000 with
NetRAID-2M (HP Rack Storage/12)
Windows NT
°
4.0 Enterprise Edition
Cluster Configuration Guide
Introduction
This document defines the server cluster configurations supported by Hewlett-Packard for interconnection of
two HP Netserver LC 2000 servers and one or multiple HP Rack Storage/12 disk drive enclosure(s), with
Microsoft
Cluster Server software.
These configurations provide high server cluster availability and
minimize single points of failure (SPOFs).
A configuration certified and supported by both Hewlett-Packard
and Microsoft
is included, but any cluster configuration that conforms to the guidelines of this document
will be supported by Hewlett-Packard.
Deviations from the supported configurations can result in an
inoperative cluster, an operating cluster with degraded performance, or hidden SPOFs.
Therefore, deviations
are not supported.
For revision/update information on this document, refer to
Versions
on page 7.
Cluster Configuration Elements
This section identifies the hardware components, system software, network interfaces, and power distribution
arrangement required to build an operational server cluster supported by Hewlett-Packard.
The various
server cluster elements are listed below, and their associated configuration data is detailed in separate tables
and illustrations that follow.
•
Server configuration
•
Shared storage configuration
•
Microsoft
and HP certified server configuration
•
Intra-cluster (heartbeat) LAN configuration
•
Client LAN configuration
•
SCSI cabling and power distribution configuration
Server Configuration
Parameter
Specification
Server
Type
HP Netserver LC 2000, Ultra3 embedded SCSI models
Number of nodes
Two
Do not mix ultra2 and ultra3 models within a cluster.
Each node must be the
same server type, but nodes may differ in their CPU clock speeds and cache
sizes, and amounts of main memory.
Clock speed
1 GHz
This certification covers any CPU speed within 500 MHz of the certified rate.
Number of CPUs
Two
BIOS
Version 4.06.04 RM, or later
CPU cache
Any size
RAM
128 MB, minimum.
Must be HP.