HP LH4r hp netserver lc 2000 netraid-3si configuration — for Micr - Page 2

lc2000nt3Si Server Configuration Parameter Number of power supplies I/O slots Default boot order Local Storage Controller Driver Physical drive location Disk drives SCSI bus SCSI Ids System Software Navigator CD-ROM Operating system Service pack Power Distribution Layout Specification One standard, two required for redundancy Added cards may be installed in any appropriate slot, considering the server default boot order provided below: IDE CD-ROM, FDD, embedded SCSI A, embedded SCSI B, PCI slot 1, PCI slot 2, PCI slot 3, PCI slot 4, PCI slot 5, PCI slot 6 Embedded SCSI, NetRAID-1Si, or NetRAID-3Si. For embedded SCSI, sym_hi.sys, version 4.12, or later For NetRAID-1Si or NetRAID-3Si, mraidnt.sys, version 2.24 (all drivers obtained from Navigator CD-ROM, version L.18.04.5, or later) Server internal drive bays, or HP external drive cabinet (e.g., HP Rack Storage/12) Must be HP (hot swapped or fixed) Any HP cables that meet SCSI specifications, and any SCSI bus speed Any Version L.18.00, or later Microsoft Windows NT® Server 4.0, Enterprise Edition SP6a Redundant power distribution units (PDUs) are recommended. See powercabling diagram on page 6. Shared Storage Configuration Parameter Specification Controller Model Number of controllers BIOS Firmware Driver NetRAID Assistant SCSI IDs Channels RAID levels Logical disks HP NetRAID-3Si Controller, Model D5955A One B.02.02 Version W.01.30 (firmware obtained from Navigator CD-ROM, version L.18.04.5, or later) Mraidnt.sys, version 2.24 Version A.01.15, or later (software obtained from Navigator CD-ROM, version L.18.04.5, or later 6, 7 0, 1, 2 1, 5, 10, 50 One per RAID array Eight, maximum, per cluster 01/26/02 2