HP LH4r HP Netserver LC 2000 Technical Reference Card
HP LH4r - NetServer - 256 MB RAM Manual
 |
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
HP LH4r manual content summary:
- HP LH4r | HP Netserver LC 2000 Technical Reference Card - Page 1
HP NetServer LC 2000 & LC 2000r Technical Reference Card HP Product No. D8514-80201, REV B, Sept. 1999 A Keyboard Lock Caution: Do not operate server for more than 2 minutes with any cover (including Power Supply Bays and Disk Drives) removed. Processor will shut down if overheated. Knockout for - HP LH4r | HP Netserver LC 2000 Technical Reference Card - Page 2
the Installation Guide. Non-Hot-Swap Mass Storage Units Flexible Disk Drive Front Panel Display Hot-Swap Mass Storage Drives P1, P2, and P3 are connected to power supplies below/behind P4 and P5 P1 P4 P2 P5 P3 Electronic Support Services • Internet Web Pages http://www.hp.com/netserver • Internet
-
1 -
2
 |
 |
HP NetServer LC 2000 & LC 2000r Technical Reference Card
HP Product No. D8514-80201, REV B, Sept. 1999
Cabinet
A
System and
I/O Board
Fan Module
Fan Assembly
Power Connector
DIMM Slots
Processor
Knockout for
External SCSI
Shelf 4: Flexible Disk Drive
Shevles
1 – 4
I/O Connectors
Rear of System Board
Non-Hot-
Swap Mass
Storage Cage
Hot-Swap Mass
Storage Cage
System
Board
Release
Screws
(2 of 4)
Pedestal Version
(Front View)
(Rear View)
Rack Version
See
C
Shelves 2 & 3: Optional
Mass Storage
See
B
See
C
Optional
Redundant
Power Supply
I/O Connectors
See
1
2
C
PCI Slots
See
C
Hot-Swap HDD
Slots 1 – 6
See
D
Hard Disk
Activity
Overtemperature
Power
Reserved
Secure
Mode
Reset
Keyboard
Lock
Power
On/Off/Sleep
Power
Indicator
Fan Fail
Front
Panel Display
Default Boot Order
1.
IDE CD-ROM
2. FDD
3.
SCSI A Bus
• SCSI Device ID 0
• SCSI Device ID 9
4.
SCSI B Bus
• SCSI Device ID 0
• SCSI Device ID 9
5.
PCI Slot P1
6. PCI Slot P2
7.
PCI Slot P3
8.
PCI Slot P4
9. PCI Slot P5
10.PCI Slot P6
RESET
System Board
Release Screw (1 of 4)
Power Supplies
1
2
3
4
5
6
1
2
3
4
5
6
Shelf 1: IDE CD-ROM Drive
6 PCI
Slots
Caution: Do not operate server for
more than 2 minutes with any cover
(including Power Supply Bays and
Disk Drives) removed. Processor will
shut down if overheated.
Mass Storage Device
Locations and Settings
B
Device
Standard
IDE CD-ROM
Standard
Hard Disk Drive
HP Accessory
9.1 GB HDD
HP Accessory
18.2 GB HDD
HP Accessory
36.4 GB HDD
Additional
SCSI device
Standard Dual
Channel SCSI
Controller
Location in order
of recommendation
Shelf 1
Shelf 2
Hot-Swap HDD
Slot 1, 2, 3, 4, 5, 6
6 Low-Profile,
3 Half-Height Drives,
or
mix LP/HH
Shelf 3
Embedded
Device Settings
Set to
Master (Default)
SCSI ID 0 (Default)
For additional HDD,
For SureStore,
SCSI ID 2
For DAT, SCSI ID 4
SCSI ID 7
See documentation with each device for further
configuration information.
See
D
Flexible Disk
Drive
PCI Slot 1
PCI Slot 2
PCI Slot 3
PCI Slot 4
Fan
Connector
SCSI A
SCSI B
32-bit
CMOS
Battery
Video
Configuration
Switch
IDE CD-ROM
System Board
Assembly
Release Screws (4)
3
2
1
0
PCI Slot 5
PCI Slot 6
64-bit
I/0
Connectors
Secondary
VRM
Primary
Processor Slot
Secondary Processor Slot
Primary VRM
Primary Temperature Sensor (U51)
Secondary Temperature Sensor (U43)
Front Panel Connector
Power Connector
For Mass Storage
Optional Redundant
Power Supply
Connectors
Power Supply
Connectors
LAN
Keyboard
Mouse
Parallel
Serial
Connector
Management
Port
System and I/O Board
C
For additional information, see other side.
DIMM Slots
*
*
*
*
CPU
Speed
Test Only (7)
Password (6)
Clear Password
Config. Memory (5)
Clear Config. (CMOS)
ON
OFF
Configuration Switch
Switch 8 Off = 133MHz FSB
733
ON
OFF
ON
OFF
ON
OFF
1
2
3
4
5
6
7
8
667
600
533