HP LH4r HP Netserver LC 3 NetRAID Config Guide for Windows NT4.0 Clusters
HP LH4r - NetServer - 256 MB RAM Manual
 |
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
HP LH4r manual content summary:
- HP LH4r | HP Netserver LC 3 NetRAID Config Guide for Windows NT4.0 Clusters - Page 1
by this guide will not be supported by HP. What's Defined • Cluster • SPUs • LANs • Local Storage • Shared Storage Cluster Type of SPUs Number of nodes Shared Storage LANs: Client Intra-cluster Power source System software: Navigator version Operating System Service pack HP NetServer LC3 Each - HP LH4r | HP Netserver LC 3 NetRAID Config Guide for Windows NT4.0 Clusters - Page 2
version CPU cache RAM Local storage I/O slots: LANs LAN connection NIC: Model Driver No. of NICs SPU I/O slot HP NetServer LC3 266 or 400 MHz. 1 - 2, but must be the same number of CPUs in each server 4.06.10 PQ Any size 64 MB minimum. Must be HP. Internal or external, using any controller. Must - HP LH4r | HP Netserver LC 3 NetRAID Config Guide for Windows NT4.0 Clusters - Page 3
bays or HP external drive cabinet (e.g., HP Storage System/6) Must be HP SPU embedded controller or any controller (any number, manufacturer or driver) in any available I/O slot (see SPU I/O slots above). Any HP cables that meet SCSI specifications and any SCSI bus speed HP NetRAID Adapter D4943A - HP LH4r | HP Netserver LC 3 NetRAID Config Guide for Windows NT4.0 Clusters - Page 4
HP Microsoft Cluster Server with One HP NetRAID Adapter 4
-
1 -
2 -
3 -
4
 |
 |
HP NetServer LC3
with
NetRAID (HP Storage System/6)
Cluster Configuration Guide
18 November 1998
Introduction
This document defines the supported HP NetServer LC3 configurations for Microsoft Cluster Server.
These configurations minimize single points of failure, provide maximum availability, and have been
certified by Hewlett-Packard and Microsoft.
This guide is prescriptive; it describes the HP NetServer LC3
configurations supported by HP.
Any configuration not expressly allowed by this guide will not be
supported by HP.
What’s Defined
•
Cluster
•
SPUs
•
LANs
•
Local Storage
•
Shared Storage
Cluster
Type of SPUs
HP NetServer LC3
Each node must be the same model SPU, but may have different size
main memory and
cache.
Number of nodes
2
Shared Storage
HP Storage System/6 with HP NetRAID controller and HP disks.
See
Shared Storage
below.
LANs:
Client
Any NIC that is HP and Microsoft approved.
See
Client LAN
below.
Intra-cluster
HP D5013A or J3171A only with crossover cable.
See
Intra-cluster
LAN
below.
Power source
Direct from power mains, power conditioner or uninterruptible power
supply (UPS) using any power conditioner or UPS.
System software:
Navigator version
L.11.00 or later
Operating System
Microsoft Windows NT Server 4.0, Enterprise Edition
Service pack
SP3 and hotfix "clusfixi", or later