HP LH4r HP Netserver LH 3 Power Supply Upgrade Manual - Page 15
Front Panel, Screws
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
Chapter 2 Cage and Power Supply Installation 3. Grasp the cage front panel and remove it from the cabinet (see Figure 2-2). Set it aside. Torx Screws Front Panel Figure 2-2. Removing the Cage Front Panel 4. Remove the power supply module from the cage, then set the new cage in the open bay. 5. Push in the cage most of the way. Align and guide the cage i nto the chassis slowly. 6. There are three connectors to attach to install the power supply cage: two large, white connectors that snap in place on the underside of the circuit board, and one small, black connector that routes through the rectangular slot in the circuit board and plugs into its top side. First, attach the two large, white connectors. Attach the inner white connector (farthest from you) first, then attach the outer white connector. Make sure both connectors "click" into place and that the plastic locks are secure. 11