HP LH4r HP Netserver LH 4: Entry-Level Enterprise Server - Page 1

Fact Sheet HP NetServer LH4: Entry-Level Enterprise Server • Processor: Up to 4 Intel Pentium II Xeon 400MHz processors with 512KB or 1MB cache. • Product Design: 8U rack-optimized configuration. LH4 can be configured in a rack or as a pedestal. • ECC Memory: 256MB 50ns ECC buffered EDO DRAM with memory scrubbing, expandable to 4GB. • Mass Storage: Up to 12 hot-swap Ultra 2 SCSI drives, (supports mixture of lowprofile and half-height drives) plus two common tray bays. • I/O Expansion Slots: 8 total full length PCI (including two 64-bit slots, one slot taken by pre-installed NIC, and one shared PCI/ISA). • Ultra2 SCSI Controller: Integrated dual Ultra2 controllers, with additional Ultra2 to single-ended converter. • Disk Array Controller: Integrated dualchannel HP NetRaid controller with I2O, supports additional HP NetRaid-3SI controller with three Ultra2 SCSI channels. • Network Interface: Bundled 10/100TX PCI LAN NIC • Tape Backup Support: Internal HP SureStore DLT for high speed data recovery, internal HP SureStore DAT November 3, 1998 24x6 autoloader for one week unattended backup. • System Management Software: HP Top Tools with intuitive browser-based interface for device management. HP OpenView ManageX/SE for NOS and Application management. • Remote Administration: Integrated HP Remote Assistant. Optional HP Top Tools Remote Control card with browser based LAN access. • Installation & Configuration: HP NetServer Navigator for faster deployment. • Power Supplies: 3 hot-swap power supplies standard, plus 1 optional, with dual cords. • Fans: 8 Totally Cool hot-swap fans standard • Support Options: Support can be delivered either by your local reseller or by Hewlett-Packard. • Solution Delivery: Racks Express offers pre-configured, pre-tested delivery of rack solutions to resellers or end users.