HP LH4r HP Netserver LH 6000 NetRAID-3Si Config Guide for Windows NT4.0 Clust - Page 3

Cabinet RAID arrays No. of cabinets Model Status SCSI ID Disk SCSI Ids Disk drives: Cables LANs LAN connection NIC: Model Driver No. of NICs A RAID array (logical disk) must be composed of all the same disk model (i.e., part number and suffix). Different size or speed disks are not allowed in the same RAID array. Any combination of disk models is allowed on a SCSI channel. Any combination of disk models is allowed in a cluster. RAID arrays may not span NetRAID Adapters. 1 - 3 Rack Storage/12 D5989B plus two D6205Bs 5 (fixed) 0 - 3, 8 - 15 (fixed) Any HP drive supported by storage enclosure including: HP 9.1 GB (7200 rpm) Low Profile Ultra2 SCSI Disk Module D6106A HP 9.1 GB (7200 rpm) Low Profile Ultra3 SCSI Disk Module P1217A HP 9.1 GB (10k rpm) Low Profile Ultra2 SCSI Disk Module D6107A HP 9.1 GB (10k rpm) Low Profile Ultra3 SCSI Disk Module P1168A HP 18.2 GB (7200 rpm) Half Height Ultra2 SCSI Disk Module D6108A HP 18.2 GB (7200 rpm) Low Profile Ultra3 SCSI Disk Module P1216A HP 18.2 GB (10k rpm) Half Height Ultra2 SCSI Disk Module D7031A HP 18.2 GB (10k rpm) Low Profile Ultra3 SCSI Disk Module P1166A HP 18.2 GB (7200 rpm) Low Profile Ultra2 SCSI Disk Module D7174A HP 18.2 GB (10k rpm) Low Profile Ultra2 SCSI Disk Module D7175A HP 36.4 GB (10k rpm) Half Height Ultra2 SCSI Disk Module D8210A HP 36.4 GB (10k rpm) Low Profile Ultra3 SCSI Disk Module D9419A Any 2 HP LVD SCSI cables from the following list: 1 meter D7131A 2.5 meter D6020A 5 meter D6982A 10 meter D6983A Intra-cluster (Heartbeat) LAN HP D5954A crossover cable or equivalent The intra-cluster LAN may only be used for cluster node communication via a crossover cable. It may not be used for client communication. Client LAN Any LAN Embedded NIC 3.27.00.0001 or later 1 Any that is on both the HP Tested Products List and the Microsoft Hardware Compatibility List. Vendor supported driver. NOTE If the NIC used is the same type as the embedded NIC (D5013A/B), then the Client LAN NIC must use the same driver as the Intra-cluster NIC 1 minimum 3