HP LH4r HP Netserver LP 2000r FC Config Guide for Windows NT4.0 Clusters - Page 2

System software: Navigator version Operating System Service Pack SPU Model Clock speed No. of CPUs BIOS version CPU cache RAM Local storage I/O slots Default Boot Order Microsoft® and HP Certified Configuration supply (UPS) using any power conditioner or UPS. Redundant power distribution units (PDU's) are strongly recommended. L.20.00 or later Microsoft Windows NT® Server 4.0, Enterprise Edition SP6a or later HP NetServer LP2000r 1 GHz 2 4.06.16 or later Any size 256 MB minimum. Must be HP. See Local Storage below. Added cards may be installed in any appropriate slot, keeping in mind the server's default boot order as listed below: IDE CD-ROM, FDD, PCI-1, PCI-2, PCI-3, Embedded SCSI P1 - Local storage (NetRAID-1M) P2 -Shared Storage HBA (D8602B) Booted from NetRAID-1M Storage Local Controller Driver May use embedded SCSI, NetRAID-1Si, NetRAID-3Si, NetRAID-1M, or NetRAID-2M. For SPOFless, recommend NetRAID-xM with internal drives in RAID5, or another fault-tolerant RAID level. For embedded SCSI, use SYM_U3.SYS version 5.05 or later. For NetRAID-xSi, or For NetRAID-xM, use MRAIDNT.SYS version 4.05 or later. Cabinets (Physical drive location) Disk drives (hot swap or fixed) SCSI bus SCSI Ids SPU internal drive bays or HP external drive cabinet (e.g., HP Rack Storage/12), any number. Must be HP. Any HP cables that meet SCSI specifications and any SCSI bus speed. Any Shared HP Rack Storage/12FC Host Bus Adapter Model No. of HBAs Driver RAID level (Required) HP D8602B 1 AFCNT4.SYS version 3.0.3245.1 0, 1, 3, 5, 10 2