HP LH4r HP Netserver LPr NetRAID-3Si Installation Guide - Page 5
HP NetServer LPr, NetRAID HP Rack Storage/12 or /8, Cluster Configuration Guide, Introduction, What'
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
HP NetServer LPr with NetRAID (HP Rack Storage/12 or /8) Cluster Configuration Guide 8 February 1999 (see Version History at the end of this document) Introduction This document defines the supported HP NetServer LPr configurations with HP Rack Storage/12s and /8s and Microsoft Cluster Server. These configurations minimize single points of failure (SPOF), provide maximum availability, and have been certified by Hewlett-Packard and Microsoft. This guide is prescriptive; it describes the configurations supported by HP. Any deviance to these configurations can result in an inoperative cluster or an operating cluster with degraded performance, hidden SPOFs, etc., and therefore will not be supported by HP. What's Defined in the Cluster Cluster SPUs Local and Shared Storage Intra-cluster and Client LANs Shared Storage Cabling Cluster Type of SPUs Installation Number of nodes Shared Storage LANs: Client Intra-cluster/Heartbeat Power source System software: Navigator version (or later) Operating System Service pack HP NetServer LPr. Each node must be the same model SPU, but may have different size main memory. Racked 2 HP Rack Storage/12 or /8 with HP NetRAID-3Si controller and HP disks. See Shared Storage below. Any NIC that is HP and Microsoft approved. See Client LAN below. HP D5013A/B with crossover cable. See Intra-cluster LAN below. Direct from power mains, power conditioner or uninterruptible power supply (UPS) using any power conditioner or UPS. L.14.00 - 400, 450 MHz with Rack Storage/12 Model D5989A L.16.00 - 400, 450, 500, 550 MHz with Rack Storage/12 Model D5989B L.17.05 - 600, 650, 700 MHz with Rack Storage/12 Model D5989B Microsoft Windows NT Server 4.0, Enterprise Edition or later SP4 or later (400-550 MHz) SP5 or later (600, 650, 700 MHz) 1