HP LH4r Installation Guide for Compaq Racks - Page 9
Overview
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
2 Overview The steps required to install the NetServer in the rack are summarized below: NOTE This is only a summary; detailed instructions are provided on the following pages. • Measure and mark the appropriate holes on all four rack columns. • Install one bar nut on each of the four rack columns. • Insert two cage nuts on each of the two front columns only. • Attach the slides to the columns. • Extend the slides. • Remove power supply modules and hot-swap drives from the NetServer. • Lift the NetServer onto the slides. • Secure the NetServer to the slides. • Remove the lifting handles from the NetServer. • Reinstall the power supply modules and hot-swap drives. • Push the NetServer back into the rack enclosure. • For HP NetServer LH 3000r and LH 6000r, attach the optional cable management arm. • Install the recessed mounting brackets on the two front columns only. • Relocate the control panel. • Install the Compaq rack-compatible bezel. 5