HP LTE Notebook PC 5000 LTE 5000 Family of Personal Computers Maintenance and - Page 238
Power Supply, Remove the bottom cover assembly as described
![]() |
View all HP LTE Notebook PC 5000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 238 highlights
Reverse this procedure to install the MPEG connector. Chapter 7.7 Power Supply The power supply is mounted in the right rear corner of the expansion base when viewed with the base placed top side down on the work surface. It is replaced as an assembly with its fan. To remove the power supply, complete the following steps: 1. Prepare the expansion base for disassembly as described in Section 7.3. 2. Remove the bottom cover assembly as described in Section 7.5.1. 3. Disconnect the power supply from the main board (Figure 7-15). 4. Disconnect the power supply fan cable from the main board (Figure 7-15).
![](/manual_guide/products/hewlettpackard-lte-5000-lte-5000-family-personal-computers-maintenance-service-guide-53e6a71/238.png)
Reverse this procedure to install the MPEG connector.
Chapter 7.7 Power Supply
The power supply is mounted in the right rear corner of the expansion base
when viewed with the base placed top side down on the work surface. It is
replaced as an assembly with its fan.
To remove the power supply, complete the following steps:
1. Prepare the expansion base for disassembly as described in Section 7.3.
2. Remove the bottom cover assembly as described in Section 7.5.1.
3. Disconnect the power supply from the main board (Figure 7-15).
4. Disconnect the power supply fan cable from the main board (Figure 7-15).