HP LaserJet 1010 HP PCL/PJL reference - Printer Job Language Technical Referen - Page 283
HP LaserJet 1100 Series Comments, AUTOCONT or DENSITY variables, the User Default and PJL
View all HP LaserJet 1010 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 283 highlights
HP LaserJet 1100 Series Comments The HP LaserJet 1100 series printers have a PJL feature set very similar to the HP LaserJet 6L printer. Listed below are some of the differences. • The INFO VARIABLES command returns the number of pages that have been copied, printed, and scanned (COPYPAGECOUNT, PRINTPAGECOUNT, and SCANPAGECOUNT). • For the LaserJet 1100 series printers, the RESET command does not initialize the PAGECOUNT, SYMSET, and PAPER variables. Instead, it sets the current value equal to the stored default value. • When a SET or DEFAULT command is used with the AUTOCONT or DENSITY variables, the User Default and PJL Current Environment settings are not modified as they are on most LaserJet printers. • For the LaserJet 1100 series printers, the INITIALIZE command does not reset the PJL variables stored in NVRAM back to the factory values. It sets their current values to the stored default values (see the following paragraph). • The HP LaserJet 1100 PJL variables can be set to factory values by performing a control panel NVRAM INIT. This is done by holding down the control panel button and cycling the power. When the power comes on, continue to hold down the control panel button. The LEDs will flash briefly when the power comes on, and then will go off. Hold the button down until the LEDs cycle once, then release the button. EN Product-Specific Feature Support A-61