HP LaserJet 9040/9050 HP LaserJet MPF Products - Configuring Security for Mult - Page 47
Configurations on the Security
View all HP LaserJet 9040/9050 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 47 highlights
Note: The Access Control List options appear next on the Network page, but you should have already configured this. The ACL instructions appear in the Initial Settings section of this chapter to help ensure security during the time you are configuring the MFPs. 9. Click to select Protocol Stacks (Figure 45), and deselect all unused protocol stacks as applicable to your network. See the table below. Figure 45: The Protocol Stacks option. The following table lists each protocol with the recommended setting and an explanation: Protocol Stack IPX/SPX Recommended Setting Leave blank to disable Explanation This setting disables access for Novell servers. TCP/IP Select to enable This is the normal operating protocol for the MFPs. DLC/LLC Select to enable This setting enables the MFP to communicate at basic levels on the network. AppleTalk Leave blank to disable This protocol provides access to older Apple and Macintosh computers. It should be disabled if not in use. 10. Select the devices to configure in the Device List, and click Configure Devices. The View Log page will appear to show the status of the configurations. Click Refresh to update the status. Once the View Log page shows success, click Go Back to continue. Configurations on the Security page The Security Configuration page lists options that are important to MFP security. 47