HP Latex 310 Site preparation guide Latex 3x5 - Page 10
Printing supplies, Return the site preparation checklist, Electrical configuration, Tools - printhead
View all HP Latex 310 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
an intermediary between computers on your local network and servers on the internet. Before setting up the printer, please check if your network requires a web proxy. To check this open Internet Explorer or Safari on any computer within your network, and browse to the http:// hp.com site. If you cannot connect to hp.com, your network does not have internet access and you need to consult with your IT provider on how to configure internet access. If you can connect to hp.com, you can check the browser settings for proxy configuration as follows: ● For Internet Explorer, click Tools > Internet options > Connections > LAN settings. In the "Proxy server" part of the window, if the Use a proxy server box is unchecked, you do not need a web proxy. If it is checked, make a note of the address and port settings in the main window, or in the HTTP part of the Advanced settings window. ● For Safari, click Preferences > Advanced > Proxies > Change settings. If the Web proxy (HTTP) box is unchecked, you do not need a web proxy. If it is checked, make a note of the Web Proxy Server name (before the ":") and port (after the ":"). ● Proxy server names typically look like "proxy.mycompany.com", and the proxy port is typically 80, but details are network dependent. If you are unable to determine whether you need a web proxy or how to configure it, please consult with your network administrator or Internet Service Provider. When in doubt, you probably do not need a web proxy. Printing supplies The following supplies should be purchased in addition to the printer and should be available on the day of installation: ● Six HP 831 ink cartridges, one for each color: black, cyan, magenta, yellow, light cyan and light magenta, and one HP 831 optimizer cartridge. ● At least one roll of substrate to perform calibrations and printhead alignment during printer setup. Return the site preparation checklist The checklist must be completed and returned to your reseller or service representative a minimum of two weeks before the day of installation. NOTE: Any delays during installation that are caused by an unprepared site will be charged to the customer. Take care that your site is properly prepared to ensure a smooth and easy installation. Electrical configuration NOTE: If configuration of the building electrical system used to power the printer needs to be modified to meet printer requirements, an electrician is required. Make sure that your electrician is appropriately certified according to local regulations and supplied with all the information regarding the electrical configuration. Your printer requires the following electrical components to be supplied and installed by the customer, according to the Electrical Code requirements of the local jurisdiction of the country where the equipment is installed. 6 Chapter 2 Site preparation requirements ENWW